diff --git a/printer.cfg b/printer.cfg
index e82f61a..2ae6fde 100644
--- a/printer.cfg
+++ b/printer.cfg
@@ -111,7 +111,7 @@ endstop_pin: PG10
 ##  (+) value = endstop above Z0, (-) value = endstop below
 ##	Increasing position_endstop brings nozzle closer to the bed
 ##  After you run Z_ENDSTOP_CALIBRATE, position_endstop will be stored at the very end of your config
-position_endstop: -0.5
+#position_endstop: -0.5
 position_max: 290
 position_min: -5
 homing_speed: 8
@@ -484,11 +484,11 @@ gcode:
 #*# [bed_mesh default]
 #*# version = 1
 #*# points =
-#*# 	  0.382500, 0.377500, 0.370000, 0.357500, 0.337500
-#*# 	  0.340000, 0.330000, 0.305000, 0.305000, 0.295000
-#*# 	  0.342500, 0.342500, 0.325000, 0.305000, 0.270000
-#*# 	  0.335000, 0.350000, 0.327500, 0.322500, 0.307500
-#*# 	  0.382500, 0.407500, 0.392500, 0.382500, 0.355000
+#*# 	0.382500, 0.377500, 0.370000, 0.357500, 0.337500
+#*# 	0.340000, 0.330000, 0.305000, 0.305000, 0.295000
+#*# 	0.342500, 0.342500, 0.325000, 0.305000, 0.270000
+#*# 	0.335000, 0.350000, 0.327500, 0.322500, 0.307500
+#*# 	0.382500, 0.407500, 0.392500, 0.382500, 0.355000
 #*# tension = 0.2
 #*# min_x = 25.0
 #*# algo = bicubic
@@ -499,3 +499,6 @@ gcode:
 #*# max_y = 287.0
 #*# mesh_x_pps = 2
 #*# max_x = 261.0
+#*#
+#*# [stepper_z]
+#*# position_endstop = 0.542