# #####################################################################
# #    Macros
# #####################################################################
# [gcode_macro PRINT_START]
# gcode:
#     {% set bed_temp = params.BED_TEMP|default(100)|float %}
#     {% set extruder_temp = params.EXTRUDER_TEMP|default(220)|float %}
#     {% set z_adjust = params.Z_ADJUST|default(0.0)|float %}
#     {% set retract = 10 %}
#     BED_MESH_CLEAR                    ; clear mesh
#     _CG28                             ; Home the printer
#     G90                               ; Use absolute coordinates
#     PARKCENTER                        ; Move to center
#     M117 Heating..
#     _HEATER_ON
#     M106 S255                         ; set print fan to full speed
#     M140 S{bed_temp}                  ; Start bed heating
#     M190 S{bed_temp}                  ; Wait for bed to reach temperature
#     M109 S{extruder_temp}             ; Set and wait for nozzle to reach temperature
#     M107                              ; turn print fan off
#     QUAD_GANTRY_LEVEL PARK=false
#     M109 S{extruder_temp}             ; Set and wait for nozzle to reach temperature
#     clean_nozzle                      ; clean nozzle
#     CALIBRATE_Z
#     #BED_MESH_PROFILE LOAD=default   ; load mesh if needed
#     # Adjust the G-Code Z offset with the Z_ADJUST parameter if needed
#     #SET_GCODE_OFFSET Z_ADJUST={z_adjust} MOVE=1
#     M117 Intro Line..
#     G90                               ; Use absolute coordinates
#     G1 Y0 X130 Z5 F12000              ; Move the nozzle to the front and near the bed
#     G1 Z0.7 F300                      ; Move the nozzle very close to the bed
#     G92 E0.0                          ; set extruder position to 0
#     G1 E{retract} F3600               ; extrude retract
#     G92 E0.0                          ; set extruder option to 0
#     G1 X180 E15.0 F500.0              ; intro line
#     G92 E0.0                          ; set extruder Poisson to 0
#     G1 X174 F6000                     ; move away from intro line
#     M117
#
# [gcode_macro PARKCENTER]
# gcode:
#     {% set Z = params.Z|default(30)|float %}
#     SAVE_GCODE_STATE NAME=PARKCENTER_state
#     _CG28                          ; Home if not already homed
#     G90                            ; absolute positioning
#     G0 X150 Y150 Z{Z} F12000       ; move to center
#     RESTORE_GCODE_STATE NAME=PARKCENTER_state
#